Cybersource Developer Community Cybersource Developer Community

kbh · 03-12-2013

We have been submitting credit card transaction requests to the payment gateway using the AIM method.Specifically, our exam fee and the convenience fee were added together and sent as one transaction request. So ifsomeone purchased a $50 exam, and ou...

kbh · 11-20-2012

In the AIM Developer Guide, p. 13-15, transaction key is listed as required. However below is our LIVE name/value pairs (without transaction key), that has been working for years. My questions are 1) how has this worked? 2) Is there a recommended lis...

kbh · 11-06-2013

Ksisler: Long story short, we did not wind up separating out the transaction fee, but kept the fee and charge in one transaction. In the case where the charge was approved, but the fee wasnt', we would have had to reverse the original charge. We plan...

kbh · 12-13-2012

Found that if I go into the user interface, "Settings", "Password-Required Mode", and check the "Require Password for ALL transactions", I get an error message when sending only the API login ID. Adding the Transaction Key results in an approved tran...

kbh · 12-04-2012

TJPride: Thank you for your reply! I've set a breakpoint at the very point where the string goes to Authorize, there is no transaction ID in the string. The value of AUTHORIZELOGIN is only the 9-character login id. Yes I also aware of the difference ...

Cybersource Developer Community Cybersource Developer Community

Your latest statistics

User Activity

New VISA requirement of separate transaction fee

Minimum Requirements for submitting transactions using AIM

Re: New VISA requirement of separate transaction fee

Re: Minimum Requirements for submitting transactions using AIM

Re: Minimum Requirements for submitting transactions using AIM

Re: Minimum Requirements for submitting transactio...